Jump to content


Photo

DSM only displays config wizard on install


  • Please log in to reply
2 replies to this topic

#1 BRodbell

BRodbell

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 12 December 2011 - 07:34 PM

At the end of the installation of DSM free version, the configuration window is displayed to allow me to enter the initial configuration. From then on when I launch it, the task runs (in task manager), but the window never launches. How can I change the configuration without having to re-run the intallation again?

#2 Brian Stern

Brian Stern

    Advanced Member

  • Technical Support
  • PipPipPip
  • 259 posts

Posted 13 December 2011 - 08:12 PM

At the end of the installation of DSM free version, the configuration window is displayed to allow me to enter the initial configuration. From then on when I launch it, the task runs (in task manager), but the window never launches. How can I change the configuration without having to re-run the intallation again?


Dear BRodbell,

Thank you for your Forum post.

Please use the following link to download and install the fixed version of the Disk Space Monitor software:

http://www.netwrix.c...mfree_setup.msi

You can install the new version over your currently installed version.

Please let me know if the new version installs successfully and fixes this issue. I await your reply.

Sincerely,
Brian Stern

#3 BRodbell

BRodbell

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 14 December 2011 - 06:11 PM

Thanks, Brian. That worked well.




0 user(s) are reading this topic

0 members, guests, anonymous users