Failed to open log 'Setup' (API used: Vista).
Posted 27 September 2018 - 01:26 PM
Posted 27 September 2018 - 01:37 PM
1. Make sure data processing account has local Administrators group membership on the target host
2. Disable windows firewall on the target host, if it does help configure necessary rules according to https://helpcenter.n...orts_Intro.html
Posted 27 September 2018 - 01:46 PM
1. It's ok
2. Will check by disabling, but it is not solution for me. No need for that configuration, for Netwrix machine there is 1configure rule -> allow any any any any
Posted 27 September 2018 - 02:03 PM
It is only needed to isolate the cause, then depending what is not working, should be changed the rules or whatever else.
Posted 28 September 2018 - 05:34 AM
Turned off and it didnt help. Same error still exists. What could it be else?
Posted 28 September 2018 - 09:33 AM
Run the following command on the target server and attach the result:
gpresult /h c:\gpolist.htm
Posted 28 September 2018 - 02:16 PM
I checked the report and did not find anything wrong, so far I do believe the issue caused by the firewall.
Please use telnet etc. to check opened ports between Netwrix and target hosts, the communication between hosts is established via ports specified at the section "13. Event Log", here is link of the article
Posted 01 October 2018 - 11:57 AM
As I mentioned earlies, there is same top rule for these servers - "accept any any any from netwrix".
Checked ports also, same raction on both servers, nothing different.
Posted 01 October 2018 - 12:14 PM
I am running out of ideas, I think you may also raise Microsoft ticket to investigate the issue.